Recrystallization Of Benzoic Acid Essay

883 words - 4 pages

Mabel M. KimbleSeptember 21, 2014Chemistry 234Recrystallization of Benzoic AcidAbstractThe recrystallization of Benzoic Acid was performed to fully master the ability to purify a solid compound. This form of purification technique is especially important in chemical identification, where the melting point of the compound is taken to confirm its purity. In order to perform recrystallization a solubility test much be completed. Four solvents (95% Ethanol, Petroleum Ether, Acetone and distilled water) were used to identify which one is an ideal solvent. An ideal solvent is insoluble in room temperature and soluble in hot solvent. 0.5mL of each solvent were added into four reaction tube with 25mg`of pure Benzoic acid. After careful observation, distilled water fit the requirement. During recrystallization, 0.5 grams of Benzoic acid were added into a 50mL flask with 10 mL distilled water. After performing this experiment, the first crop had a mass of .334 grams with a second crop of 0.0grams. The percent recovery yields 66.8%, which means that according to expected value of 70% this data confirms that the Benzoic is pure. Finally, the melting range was between 120 to 122 degrees which again confirms that the recrystallized Benzoic acid has been purified completely.IntroductionRecrystallization is a commonly used method of purifying solid compounds. Insoluble impurities get extracted from the compound by dissolving the mixture in hot solvent. The soluble impurities are dissolved in a high temperature environment and the solvent is cooled in room temperature while Benzoic acid crystallizes. The crystalized Benzoic acid is then placed in an ice bath to cool it further. The crystals are then filtered out using the vacuum filtration provided in lab. The filter paper is taken out and crystallized Benzoic Acid is dried out. Overall, the prediction for this experiment would be that the percent recovery will yield a low outcome.Purifying Benzoic acid by using heat through hot solvent, filtering the crystal, cooling and drying could have resulted in some of the liquid staying in the gaseous state (evaporation).Experiment DetailsSolubility testIn order to find the ideal solvent for recrystallization 25 mg of pure Benzoic acid with 0.5mL of each solvent (95% Ethanol, Petroleum Ether, Acetone and distilled water) is added into a reaction tube. Four tubes is placed in hot solvent and room temperature. The goal is to identify an ideal solvent in which Benzoic acid will be insoluble in room temperature and soluble in hot solvent. In room temperature, distilled water and petroleum ether were insoluble while, acetone and 95% ethanol were soluble. In hot solvent, acetone and ethanol were insoluble while, petroleum ether and distilled water were soluble. Both tubes were placed in an ice bath for crystallization and both produced the same results...

Find Another Essay On recrystallization of Benzoic acid

Chemistry lab report

1106 words - 4 pages The goal of the project was to characterize an "unknown" organic acid in order to make a proper identification of the acid, while learning proper techniques for scientific measurement and analysis of error. In order to ensure the most accurate data, a purification was performed by the process of recrystallization. To perform the recrystallization the powder was dissolved in a minimal amount of hot ethanol/H2O solvent that allowed the unknown

Melting point lab Essay

1376 words - 6 pages watch glass = 49.913gMass of crystals recovery = 1.235gSample of unknown melting point = 112 ºCUnknown and Toluic acid melting point = 112 ºCUnknown and Acetanilide melting point = 92 ºCUnknown sample is Toluic AcidCalculations;% recovery = Mass of watch glass - Mass of crystals and watch glass * 1002.000g% recovery = 48.678 g - 49.913g * 1002.00g% recovery = 61%Discussion;Recrystallization proved to be a somewhat effective method of

Organic Synthesis of Aspirin Chemistry Formal Lab

1385 words - 6 pages Experiment Four: Organic Synthesis of AspirinAbstractThe purpose of this experiment is to synthesize a common organic product called acetylsalicylic acid (aspirin), and to become familiar with the optimum conditions needed for successful yields. Aspirin is produced from an acid catalyzed reaction between salicylic acid with acetic anhydride. The crystalline aspirin is synthesized and purified by recrystallization, although there is not a hundred

EXPERIMENT 2

2003 words - 9 pages product results from either a syn or anti addition of Br2 to the alkene. Recrystallization using ethanol and water solvent mixture was used to purify the crude product and melting point was implemented in order to see which products were synthesized. The syn addition products (2S, 3S- and 2R, 3R) 2,3-dibromo-3-phenylpropanoic acid have a melting range of 93.5-95 ᵒC. The anti addition products (2S, 3R- and 2R, 3S) 2,3-dibromo-3-phenylpropanoic acid

Acid base Extraction

1356 words - 5 pages = 5.15) to dissolve in NaHCO3 the reaction would proceedforward.5) a) 1g benzoic acid x 1mol = .00699 mol benzoic acid143g benzoic acidb) 1ml 10% solution NaHCO3 x 1g_ x 1mol = .00116 mol NaHCO34ml 96g NaHCO3.00699 moles of benzoic acidIntroduction:The purpose of the second part of this laboratory assignment was to extractcaffeine from tea using dichloromethane and then to confirm the identity of it bypreparing a derivative of the extracted caffeine

Preparation and Recrystallisation of Aspirin

2422 words - 10 pages 1.SynopsisThe objective of this experiment is to learn to re-crystallise aspirin and to prepare aspirin.To find out the purity of aspirin obtain by recrystallisation of prepared aspirin from reaction of salicylic acid with acetic anhydride. Purity can be determined by identify the melting point of aspirin. In this experiment, we get a range of 135.8°C - 136.7°C melting point of the synthesized aspirin. Comparing with the theoretical

Acid Base Extraction

1356 words - 5 pages acids neutral organic compounds and basic organic substances. The procedure for this laboratory assignment are on the following pages. 3) Separation of Carboxylic Acid, a Phenol and a Neutral Substance      The purpose of this acid/base extraction is to separate a mixture of equal parts of benzoic acid(strong acid) and 2-naphthanol(weak base) and 1,4- dimethoxybenzene(neutral) by extracting from tert-butylmethyl ether

Chemistry: Gas-Liquid Chromatography

1360 words - 5 pages isobutyrate and phenylacetate are esters of 2-phenylethanol that are used in perfume (see Figure 3). Toluene When toluene goes under air oxidation benzoic acid is formed. Benzoic acid is then used in the formation of benzoate ester and benzophenone. The chlorination of toluene under radical conditions gives mono, di, and trichlorotoluene. The benzyl chloride that is produced can produce benzaldehyde through hydrolysis (addition of water). The

Black Pride

909 words - 4 pages meets with those who "shoot the mess Oxoacids HClO4, perchloric acid HNO3, nitric acid HClO3, chloric acid HNO2, nitrous acid HClO2, chlorous acid HClO, hypochlorous acid H3PO4, phosphoric acid H3PO4, phophorous acid H2SO4, sulfuric acid H2SO3, sulfurous acid H2CO3, carbonic acid Organic Acids HCOOH, formic acid CH3COOH, acetic acid C6H5COOH, benzoic acid

science

2388 words - 10 pages to cool to room temperature before it was placed into an ice water bath for complete recrystallization to occur. The crystals were collected using suction filtration using the Buchner funnel and were spread out to dry on a filter paper on a watch glass under an infra-red lamp.Results and CalculationsMass of watchglass with filter paper = 32.7790gMass of watchglass with filter paper and salicylic acid crystals = 34.3500gMass of salicylic acid

Chemistry Project: Acids and Bases & the pH Scale

1522 words - 6 pages alkaline, a base,and neutralizes the acid secreted by the parietal cells, producing water in the process.This continuous supply of bicarbonate is the main way that the stomach protects itselffrom the stomach digesting itself and the overall acidic environment.Monoprotic acids have a single H+ ion, or proton, they can donate when acting asBronsted acids. Hydrochloric acid (HCl), acetic acid (CH3CO2H), nitric acid (HNO3),and benzoic acid (C6H5CO2H

Similar Essays

Recrystallization Of Benzoic Acid Essay

883 words - 4 pages Mabel M. KimbleSeptember 21, 2014Chemistry 234Recrystallization of Benzoic AcidAbstractThe recrystallization of Benzoic Acid was performed to fully master the ability to purify a solid compound. This form of purification technique is especially important in chemical identification, where the melting point of the compound is taken to confirm its purity. In order to perform recrystallization a solubility test much be completed. Four solvents (95

Recrystallization Essay

1269 words - 5 pages in.The crystals on the wet filter paper were transferred onto a fresh piece of filter paper and were allowed to air-dry.Once the crystals are dried, the weight was taken and recorded.Observations & Results:Original weight of benzoic acid = 1.95gWeight of filter paper = 0.54gWeight of filter paper + benzoic acid crystal = 2.32gWeight of benzoic acidcompound recovered after recrystallization = 2.32 - 0.54= 1.78gweight of compound

The Gum Benzoin Tree Essay

3705 words - 15 pages correct personal protective equipment (PPE) should be used at all times and a well ventilated work space should be maintained. Benzoic acid is stable under standard/normal laboratory conditions (SLC). Organic compounds are compounds that consist of carbons that are covalently bonded together. Recrystallization is the method of purifying solid organic compounds. Purification or purifying is the removal of all contaminates/impurities from inside

Cyalume Essay

1222 words - 5 pages inorganic molecules from the organic layer performs neutral extraction.Acidic extractions are used to convert an organic base into its water-soluble form so it can be moved into an aqueous layer.Basic extractions are used to convert an organic acid into a carboxylic salt so it can be moved into an aqueous layer.Steps to identify unknown liquidsseparate the components of the mixture using separatory funnelperform recrystallization on unknown